Ive attached 3 images for you to compare at he image quality (excuse the state of the Garden, had to keep the kids entertained during lockdown). So maybe its better to install the IR at the front of your house, then a normal LED next to the camera. an IR floodlight would be better for the distance subjects (but that caravan might cause an issue. When the normal floodlight comes on, it lights up the scene and it throws enough light to sharpen up the image, but the is only suitable for close subjects. To do this, on the NVR webpage go to Network > Advanced Settings > Other then check the box "Enable Virtual Host" and save. Firstly you'll need to enable the virtual host feature on the NVR. Some of the image settings we mentioned in the other thread are only available when you log in to the camera itself via its own web page. Yes you'll cover your neighbours property but you can always add a privacy zone if they're unhappy about it. This is to avoid a situation where the NVR menu displays a setting that has been changed in the camera and therefore reads incorrectly.įor that camera, the first thing I would do is pan the camera right to avoid the wall. Only make changes directly in the camera webpage that cannot be made on the NVR webpage. Log in to the camera web page with the same details for your NVR. Alternatively in the NVR menu you'll notice that once virtual host is enabled, you can go to System > Camera Management and there will be a hyperlink for each camera enabling you to click straight to the camera webpage. For instance if your NVR is at 192.168.0.100 you'll want to enter to access the camera directly. Once thats done just open another page in your web browser and append the NVR IP address with the port number. Is this an issue with the location of the camera or are there likely to be settings I can adjust to resolve this issue? Or do I need a different camera? I tried to put a privacy mask over the wall area hoping that the camera would ignore that area altogether but it did nothing.Ĭlick to expand.Some of the image settings we mentioned in the other thread are only available when you log in to the camera itself via its own web page. The camera seems to be illuminating the side wall and thus missing the car (apart from number plate). I have attached photos of the screen daytime and nighttime. However, when it went dark I can't see the car in my drive - which I could on the Swann which was positioned in exactly the same place. I was very pleased with the image quality compared to the Swann - as I expected to be. I used this forum to update the firmware of the NVR (thanks!), though I haven't managed to update the firmware on the camera yet. Hikvision DS-7604NI-E1/4P/A NVR and DS-2CD2135FWD-I camera. I only needed one camera and bought the following second hand. Yesterday I installed a Hikvision NVR and camera yesterday to replace a very old Swann system.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |